return - return from a function
return [n]
The return utility shall cause the shell to stop executing the current function or dot script. If the shell is not currently executing a function or dot script, the results are unspecified.
None.
See the DESCRIPTION.
Not used.
None.
None.
Default.
Not used.
The standard error shall be used only for diagnostic messages.
None.
None.
The value of the special parameter '?' shall be set to n, an unsigned decimal integer, or to the exit status of the last command executed if n is not specified. If the value of n is greater than 255, the results are undefined. When return is executed in a trap action, the last command is considered to be the command that executed immediately preceding the trap action.
Default.
None.
None.
The behavior of return when not in a function or dot script differs between the System V shell and the KornShell. In the System V shell this is an error, whereas in the KornShell, the effect is the same as exit.
The results of returning a number greater than 255 are undefined because of differing practices in the various historical implementations. Some shells AND out all but the low-order 8 bits; others allow larger values, but not of unlimited size.
See the discussion of appropriate exit status values under exit.
None.
IEEE Std 1003.1-2001/Cor 1-2002, item XCU/TC1/D6/5 is applied so that the reference page sections use terms as described in the Utility Description Defaults ( Utility Description Defaults). No change in behavior is intended.